11 Best Muzzle Brake For 300 Win Mag (2023 Updated)

I choose this brakes becose I have extreme heavy electric bike, his wheit is almost 61kg with battery and motor, my wheit is around 100kg, imagine how big powers have to work to stops my bike from speed 50km/h.

I try many diffrent brands and brakes, but only magura hs33 work as I need. They are just perfect, highly recomended.

Awesome, Great brakes for v brake by magora

loved the brake sgot them when i traded a friend brakes made me so happy i gave away 3 sets that i brought

Works fine as a drum brake adjustment tool. The bends don’t seem to make that much of a difference than a small pry bar, though.

This tool fit perfectly! The bends offer a variety of angles to reach the sprocket. The metal is very strong. The width left a little wiggle room.

The right tools for a job make the job so much easier, and this tool worked great. It’s pretty sturdy and strong for what it may look like. I had no issues using it, no bending or flex. It is narrow enough to get into the brake adjustment slot and to also allow for a thin flat blade screw driver to get into the slot also so as to release the adjusting lever.

I’ve been trying to find something wrong with this call, and I can’t. When I was new to calling, I needed something easy to blow, because as a former smoker, my lungs were trash. Looked everywhere for reviews on this issue and found nothing.

Bit the bullet and went with this call. The call quality is top notch. The sound is even better. And the best part – that reed breaks over so easy. You don’t need to be a pro to blow this call. But you’ll sound like one.

3 years later – if I had to grab ONE call to take in the layout – this is it. You won’t be disappointed. Getcha one.

When I first bought this call, I was a little disappointed. As a neophyte goose hunter, I was hoping a more expensive call would be easier. And this call is expensive. In reality, it is like a better quality violin, and can perform with more subtle nuance and control but takes practice.

To master it, it might take a little work, but not too much. In the end, it will sound like a goose and not a kazoo. I recommend it.

This call is my favorite call I’ve blown/owned. I’ve had calls from zink, sean Mann, Tim grounds, Jeff foiles and have blown almost all others. I think this is the best call out there. You can get high pitch and low pitch sounds out of it.

However it is a call that requires more air and attention to back pressure. I’m not saying that the other calls I own/owned were not good, they were. Especially the zink N. O. S and C. O. D as well as foiles SMH, they all sound great.

However I like that the Tim grounds calls take more air to run. I feel more sounds can be attained from this more consistently with greater range on the bottom (the call doesn’t break over to easily or when you don’t want it to).

Some will say that it is tuned tight or that it won’t break, I assure you that they all will. These calls are all hand tuned by the grounds crew. They just take some getting used to with air presentation and the back pressure.

Bottom line is if you put the time into learning how to blow the call, it sounds great and is one of the most versatile calls on the market.

Nice thread protector at a reasonable price. Threads are perfect and it fits nicely. Threads are protected now until I decide what type of suppressor I’m going to go with.

I bought a Bergara Terrain with a muzzle brake. I don’t care for muzzle brakes especially for hunting so I bought this thread protector to replace it. It works fantastic & fits like it was factory installed.

Good quality.

This thread protector threaded right up on my. 40 caliber barrel for my AR SBR conversion. It will work until I can afford my suppressor. Fit, finish, and font I’ll I’m n as advertised.

It’s so nice to spend the extra money on a product and actually get the expected quality and performance. Box One V brakes are the best on the market. It doesn’t hurt that they look great. Many thanks.

Great brakes. Open the box, which put theme on bike and they work very well and easy to adust. Hex adusting screws last longer than Phillips head screws.

These brakes are awesome !!! They look great but most importantly, is they work very well and are easy to adjust with the Allen key screw instead of the Phillips head screw.

My mechanic installed this booster into my 67 Firebird. I updated the entire brake system from factory drum brakes to Wilwood disk brakes on all four wheels and tried a Right Stuff drum that totally failed.

This booster has an adjustable push rod, which made the install very easy. They were able to replace the factory 11″ brake booster with this 9″ booster and had the brakes working perfectly! If your updating to Wilwood disk brakes and Wilwood Master Cylinder this booster is the perfect match.

It sits closer to the firewall than the Right Stuff piece of junk and is smaller in diameter than the factory booster. So, provides a ton of extra room, the look is awesome and performs great.

I bought this booster as a direct bolt-in for my 63 impala. I wanted something smaller so I could remove valve covers easier. This booster requires complete removal of your factory booster, brackets, rods.

(Which is fine). But it also does not work with your factory master cylinder. So unless you can re-bore your mastercylinder, you will need to replace with one of Leed Brakes mastercylinders. HOWEVER they do not offer a single/factory style mastercylinder.

In order to use the one suggested by Leed Tech Support. You will need to re-plub you’re break lines an add a proportion valve. Also this does not operate as good as my factory booster. I would not by this again.

Just buy factory or a full kit. (Booster does look good tho.

I had bought a no-name booster & master cylinder for my 56 Belair off ebay. The studs that hold the master cylinder to the booster pulled out while bleeding the brakes! This unit from Summit fit perfect, functions as expected, and I know have excellent brakes on the 56.

Ordered one day, delivered the next. Fantastic service, as always.

my bike: 2016 ninja 300, non abs. For 50 bucks, this is really a no brainer. Why bikes dont come from the factory with SS lines is beyond me. Install was pretty smooth. 10/10 product. The only beef I have is the stock line has two brackets securing the line, and this kit came with one.

The stock brackets are right above the caliper, and right below the triple tree. I chose to mount it below the triple tree (a bit more than 50% of the distance from the master to the caliper) as the one by the caliper seemed redundant having the wire cage holding the line in its general position, and the banjo bolt a few inches away really locking it down.

I moved the bars to full lock on either side and noticed no pulling or pinching. Despite not having both brackets in use, there are absolutely no issues that cause me concern. If I really wanted to I could have modified one of the brakets from the stock line, but I dont see the point.

I put in EBC sintered pads while I had the caliper off, bled the brakes and noticed an immediate improvement. 60 miles into bedding the pads and the feel and responsiveness is just getting better and better.

Seriously, one of the best upgrades for keeping you safe besides better tires. Dont get a tail tidy or clip ons, or anything else cosmetic untill you’ve gotten stainless lines, quality pads/rotors, and quality tires.

Safety mods first, we’ve got enough stuff to worry about being on public roads.

Ordered this line not because I was seeking the upgraded performance of stainless steel lines, but rather because it is the most affordable line I could find. The upgraded performance is a bonus. Installed super easy and looks nice to boot.

Only complaint at the moment after install is that the line is longer than the factory OEM line. Not sure how, if at all, this will contribute to noticeable brake feel due to the extra length. I will say that the Spiegler front brake lines received in a kit were near matches right up to the master cylinder like OEM lines.

This muzzle break what it says it does. Felt recoil is virtually gone. Flash suppression is also almost zero. However, I do not recommend this for anything less than 18”. The concussion felt by the shooter is teeth jarring and makes for an unpleasant shooting experience.

Would I buy this again? No.

Very little recoil ,no muzzle jump . Very quick recovery for second shot . I have 2 of these on my rifles love both of them.

My first muzzle break, so I have nothing to compare it with. That being said, I like it. Helps with muzzle rise and recoil.

Works great with Odi lock on grips. Spring back feature makes it easy to use. Quality is amazing.